This document describes Slurm site_factor plugins and the API that defines them. It is intended as a resource to programmers wishing to write their own Slurm site_factor plugins.
Slurm site_factor plugins are Slurm plugins that implement the Slurm site_factor API described herein. They are designed to provide the site a way to build a custom multifactor priority factor, and will only be loaded and operation alongside PriorityType=priority/multifactor.
The plugins are meant to set and update the site_factor value in the struct job_record corresponding to a given job. Note that the site_factor itself is an unsigned integer, but uses NICE_OFFSET as an offset to allow the value to be positive or negative. The plugin itself must add NICE_OFFSET to the value stored to site_factor for proper operation, otherwise the value itself will be extremely negative, and the job priority will likely drop to 1. (The lowest value that does not correspond to a held job.)
Plugins must conform to the Slurm Plugin API with the following specifications:
const char plugin_type="major/minor"
The major type must be "site_factor" The minor type can be any recognizable abbreviation for the specific plugin.
const char plugin_name
Some descriptive name for the plugin. There is no requirement with respect to its format.
const uint32_t plugin_version
If specified, identifies the version of Slurm used to build this plugin and any attempt to load the plugin from a different version of Slurm will result in an error. If not specified, then the plugin may be loaded by Slurm commands and daemons from any version, however this may result in difficult to diagnose failures due to changes in the arguments to plugin functions or changes in other Slurm functions used by the plugin.
The following functions must appear. Functions which are not implemented must be stubbed, or the plugin will fail to load.
Called when the plugin is loaded, before any other functions are called. Put global initialization here.
SLURM_SUCCESS on success, or
SLURM_ERROR on failure.
Called when the plugin is removed. Clear any allocated storage here.
Note: These init and fini functions are not the same as those described in the dlopen (3) system library. The C run-time system co-opts those symbols for its own initialization. The system _init() is called before the Slurm init(), and the Slurm fini() is called before the system's _fini().
Description: Refresh the plugin's configuration. Called whenever slurmctld is reconfigured.
void site_factor_p_set(struct job_record *job_ptr)
Description: Sets the site_priority of the job, if desired.
job_ptr (input) pointer to the job record.
Description: Handle periodic updates to all site_priority values in the job_list. Called every
These parameters can be used in the slurm.conf to configure the plugin and the frequency at which to gather information about running jobs.
- Optional parameters for the site_factor plugin. Interpretation of any value is left to the site_factor plugin itself.
- Specifies which plugin should be used.
- Interval between calls to site_factor_p_update()
Last modified 24 April 2019